Get Answers from our
Community of Computer Experts

When I start up my computer, Dell Vostro 220s desktop, it makes two short beeps and doesn't work even though it sounds like it is running.


2017/03/08 16:40
0 Like It
I tried installing a new hard drive that I ordered on Amazon last week and that is when the problem started.
Operating System:
Windows 10
Answer this question
best answer

 
Answered by
Ryan Bacolod
2017/09/05 02:07
Hi Guillermo,

I am sorry to hear that.

The computer might emit a series of beeps during start-up if the display cannot show errors or problems. This series of beeps, called a beep code, can be used to help identify various problems.
  1. 3 means 3-3-3-3...That is 3 beeps and 3 beeps and ...: Endless looping until user presses the power button to shut down the system.
  2. The delay between each beep is 300ms. The delay between each set of beeps is 3 sec, and the beep sound lasts 300ms.
  3. After each beep and each set of beeps, the BIOS should detect if the user presses the power button, if so, BIOS will jump out from looping and execute the normal shutdown process and power system.
In your case, you have said that your computer beeps twice. 2 beeps means No RAM Detected/No memory detected.

A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them.

To troubleshoot, please turn off your computer and then unplug it from the power source.
  • Remove RAM stick(s)
  • Remove your Hard Disk and clean all the chords including your Motherboard
  • Put back the RAM stick(s) and your hard disk but not including the new hard drive
  • Plug your computer into the power source and then turn it ON.
If your computer turns on, then your new hard disk is faulty. Do not attach it again because it will only cause problems. You may take advantage of its warranty to have it replaced.

However, if your computer still doesn't turn ON, you should hear another beep. Please count it and let us know how many beeps.

I hope this helps.

Regards,



Ryan


Comments
Commented by adv ydv
2018-10-13 19:15:21
Command Prompt is connected to Windows 10, then this visit, and I hope you like this command prompt info, then click on this portal Open Command Prompt Windows 10 , we have learned how to command your desktop. So you can follow the steps in the steps

Cancel

There are no answers yet.

Welcome to Reviversoft Answers
ReviverSoft Answers is a place to ask any question you have about your computer and have it answered by the expert community.
Post your question
Ask your question to the community now
Similar questions
Started happening about 3 weeks ago at the same time as I had the HD replaced.
VIEW ANSWERS
19
Show full question
mein pc ist put mochte nun reviversoft auf mein laptop registriren wie geht das und was muß ich tun
VIEW ANSWERS
19
Show full question
I kept getting the blue screen with Driver Power State Failure error message and then my computer would restart. I found your product and it did not happen any more. I just purchased an anti-virus (kaspersky) and now it is doing it again. It is so frustrating. My computer is only 6 months old. It is a Asus desktop.
VIEW ANSWERS
8
Show full question
Having trouble with your PC?
Complete a free PC scan using Driver Reviver now.
Download
Start Free Scan
Copyright © 2024 Corel Corporation. All rights reserved. Terms Of Use | Privacy | Cookies
follow us
Only today
Save 80%
On the black friday bundle
Three amazing products, one low price! Optimize, repair, and boost your PC in just one click!

HURRY! This deal expires in...

00
hour
:
00
minute
:
00
second